# Engineering Graphics(Mechanical)0509-1510

Lecturer: Miriam Almor
Fall Semester (A), 2003-2004

 Technical DrawingSummaries by Yossi
• Introduction to Manufacturing Symbols: Surface Finish & Geometric Tolerances

• Introduction to FITS & TOLERANCES

• Introduction to ASSEMBLY Drawings

• Introduction to DIMENSIONS

• Introduction to SECTIONS & Conventions

•  Descriptive GeometrySummaries by Yossi
• Introduction to Surface InterSections & Developments

• Introduction to Surface Sections & Developments

• Plane Intersections & HLR (Hidden Line Removal)

• True Size & Inclination Angle of Lines & Planes

• Introduction

•  Technical DrawingYuval's Pointers
• Introduction to Manufacturing Symbols: Surface Finish & Geometric Tolerances

• Introduction to FITS & TOLERANCES

• Introduction to ASSEMBLY Drawings

• Introduction to DIMENSIONS

• Introduction to SECTIONS & Conventions

•  Technical DrawingeDrawings – 3D VIZ

### Exercise 8 - 3D VIZ :

• VISE Assembly - MODEL

• VISE Assembly - DRAWING

• BASE - Part MODEL

• JAW - Part MODEL

• HANDLE - Part MODEL

• ### Exercise 7 - 3D VIZ :

• AIR REGULATOR Assembly - MODEL

• AIR REGULATOR Exploded Assembly MODEL

• ### Exercise 6 - 3D VIZ :

• ASSEMBLY: MODEL of Pulley HOLDER

• ASSEMBLY MODEL of Pulley HOLDER - Threaded Alternative

• ### Exercise 5 - 3D VIZ :

• SLIDE BEARING Assembly - MODEL

• SLIDE BEARING Assembly - DRAWING

• ### Exercise 4 - 3D VIZ :

• STRIPPER BRACKET - Part MODEL

• ADJUSTABLE BEARING 1 -Part MODEL

• DIMENSIONS: DRAWING 3.1.2

• CLUTCH FINGER - Part MODEL

• ADJUSTABLE BEARING 2 - Part MODEL

• DIMENSIONS: DRAWING 3.2.2

• ### Exercise 2 - 3D VIZ :

 Descriptive GeometryeDrawings - 3D VIZ

• Exercise DG5 - InterSections &
Surface Developments - Model

• Exercise DG5 - InterSections &
Surface Developments - Drawing

• Exercise DG3- Plane InterSections & HLR